Mixer Setup

The sole purpose of the WiFi setup is so you can connect an iPad to run the TouchMix control App for remote control or to use the iPad as an extension of the mixer's local touchscreen.
Category: TouchMix - Mixer Setup

The purpose of the Talkback Mic is to communicate to the audience through the main PA and/or to communicate with personnel on stage through speakers located on stage or in a remote location. This would require that the Talkback Mic to be routed to on…
Category: TouchMix - Mixer Setup

The mixer has two available screen modes that will globally affect what controls that are visible when looking at the EQ, Dynamic Processing, and FXs.
Category: TouchMix - Mixer Setup

The TouchMix does not have a dedicated “Sub” output with Low Pass filtering so the LF management would have to happen outside of the mixer.
Category: TouchMix - Mixer Setup

The Reset function is a way to quickly get the mixer back to a "Factory Default" state. This process will reset all fader levels, EQ settings, Dynamic processing, and Effects Processing back to the factory default, as well as reset all Mute and DCA g…
Category: TouchMix - Mixer Setup

The Reset function is a way to quickly get the EQ or Dynamic Processing back to a "Factory Default" state. This process is very similar to the "Reset Mixer" but will ONLY reset the associated EQ, Compressor, Gate, Filter, or Graphic EQ.
Category: TouchMix - Mixer Setup

A firmware update for the TouchMix mixer requires that the latest firmware to be downloaded from the QSC Website.
Category: TouchMix - Mixer Setup

There are two options for the Cue Mode which does affect how the Headphone Cue and the Monitor Cue tap in to the audio path of the various input and output channels on the mixer.
Category: TouchMix - Mixer Setup

There are two Sample Rate options available on the TouchMix: 44.1 kHz and 48 kHz
Category: TouchMix - Mixer Setup

The TouchMix LCD screen’s brightness can be adjusted by performing the following steps.
Category: TouchMix - Mixer Setup

Phantom power is only required when microphones with active electronics such as condenser microphones OR Direct Input devices with active electronics are connected to an input channel.
Category: TouchMix - Mixer Setup

The purpose of the Noise Generator is to send Pink Noise out single or multiple outputs to test audio output to those locations.
Category: TouchMix - Mixer Setup

The Gain Wizard is a tool that can be used to help establish proper gain structure on front end of the mixer. It will help you in determining how much headroom you should give to a signal that is clipping at the input.
Category: TouchMix - Mixer Setup